PolyJet Part Quality Troubleshooting Guide

Stratasys Support Center – Part Quality Guide - Material Drippings on the Tray

Material Drippings on the Build Tray

Sometimes, material drips on the build tray during a print job.

 

  

 

Possible Causes and Solutions

Roller Waste Collector Full or not Draining 

If the roller waste collector is full or not draining properly it overflows and material may leak and drip onto the build tray.

Solutions: 

  • Clean the roller waste collector.
  • Make sure the suction tube is in its proper place and working.
  • Verify that the roller scraper is not damaged. 

If you are still experiencing issues, please contact your Customer Support representative.

Preventive measures:

  • Clean and maintain the roller waste collector once a week.
  • Run the Cleaning wizard before and after every print job.  Make sure to clean properly between prints and maintain the printer properly. See the User Guide for instructions
  • Replace the roller scraper if necessary. If you are using one of our desktop printers, replace the roller waste collector assembly. See the User Guide for instructions. Also, periodically test the effectiveness of the roller scraper when you clean the roller waste collector. Replace the roller scraper blade after 1,000 hours of printing or if it does not effectively keep the roller clean, whichever comes first.

For more detailed instructions, see the Routine Maintenance Tasks in the User Guide.


Frequently Asked Questions

Learn what other users are asking about their printers.

READ NOW

We want to introduce some of the new and improved features.

Helpful hints will pop up as you explore the site for the first time. Click on the icon at the top of the page if you want to see the hints again.