Installing the New Head
|
1.
|
Inspect the replacement head, and make sure that the O-ring seals are in place. |
|
2.
|
Gently insert the replacement head into the vacant slot in the print block, and push the print-head driver card into its socket. |
Note: Make sure to insert the head with the driver card facing its socket, in the rear of the print block.
|
3.
|
Push the head up until you hear it click into place, in both front and rear holders. |
|
4.
|
Lower the door of the print head compartment, and tighten the screws to lock it in place. |
|
5.
|
Tighten the upper and lower screws that secure the print head in the print block. |
Note: Hand-tighten these screws. Do not use a screwdriver.