Advanced Settings

The Advanced Settings dialog box enables you to configure the Material Replacement wizard for special purposes. If necessary, click Advanced Settings in the Material Replacement Options screen before clicking Next.

Positioning

By default, Automatic slot selection determines the best slot locations for the cartridges in the material cabinet, based on materials currently in the system. This ensures minimum flushing of materials currently loaded.

Select Manual slot selection—

•

if there is a special need to load cartridges in certain slot locations.

•

if you only want to change one of the cartridges for a given material channel.

Some materials cannot replace certain other materials. If you attempt to do so, the wizard notifies you.

To select the slots for the cartridges manually:

1.

In the Material Replacement Options screen, click Advanced Settings.

2.

In the Advanced Settings screen, select Manual slot selection, and click Apply.

3.

In the Material Replacement Options screen, Both cartridges is selected for each position. To print with only one of the cartridges, clear the check box and then select either the left (L) or the right (R) cartridge.

Note: When changing Support material, select at least two Support material cartridge slots—one from A (either L or R) and one from B (either L or R).

When printing in High Speed mode (three materials), the same material is used in both sections of each print head. The material selected for one of the cartridge slots is also used in the other print head channel.

4.

After selecting the materials for the appropriate cartridge slots, the Cartridge Positioning screen appears. Place the cartridges in the materials cabinet as shown in this screen.

Additional Flushing Cycles

The flushing cycle you select in the Material Replacement Options screen determines how thoroughly to flush out material currently in the system. After selecting the Economy cycle and completing the wizard, you might decide that you require a more thorough flushing, to ensure accurate model color. Or, you may notice that printed models are not satisfactory because they contain traces of the previous material. If so, you can flush out more material, so that the next models will be printed with pure material.

To perform additional flushing cycles:

➢

In the Advanced Settings screen, select Enable "flush again" options and click Apply.

The Material Replacement Options screen appears, where you can select the material(s) you need to flush again.